Features:
Employs spindle motors 6000rpm
Scoring saw features a swing jumping design to prevent work-piece end tearing off after cut .
Spindle tofully prevent work-piece tearing or burrs occurring while upgrading product quality(optional equipment).
The pillar of left & right up-press system, using two pillars and upward design.It can keep pressing went with an even motion.
Extra wide and span combine with liner rail-guides, ball spiral shaft and digital position-displayer for the traverse of movable beam. It is more easy and convenient with accurately.
Use a precision feed track which incorporates with auto lubricated, replaceable rail and the feeding dogs have multip constitute can automatically adjust height and distance according the processing material.
Saw blade & spindle drive motor, that depent on processing require adjusting, such as rotation speed of saw blade and spindle , feeding speed ..etc.
 |
 |
 |
*Middle auxiliary support stand.(standard equipment)
*The entire series product all may voluntarily install is automatic out-feed the material frame. |
*Middle auxiliary up press (optional equipment).
* May install automatically in-feed the material system.(optional equipment) |
*Using special steel, hight tensile strength & high accuracy.
* Air tight needle bearing. |
 |
 |
|
| *Dogs have mulitiple constitute can automatically adjust height and distance according the processing material. |
|
|
 |
 |
 |
 |
| * The buttom supports and top pressure device, it set up at cut spindle. that is for promote the accuracy of processing. |
* Horizontal :Extension spindles (available for direct drive units) for machining operations inside the feed belt. This enables the use of cutting, grooving and scoring tools on section of the work-piece between the feed belt. |
* Vertical:Perfect hogger units coupled for squaring panels; recommended for large series production at high feed speeds. |
* Slope :Matching dovetail edge andDovetail groove machining operation. |
Description :
| MODEL |
KDET-8 with 802 |
| Down scoring saw |
1.8~5.0 kw |
3000(5)/6000(O) R.P.M. |
| Cut-off saw |
5.5~8.0 kw |
3000(5)/6000(O) R.P.M. |
| Spindle |
5.0~8.0 kw |
6000 R.P.M. |
| Feeding motor |
1.5~5.5 kw |
M/min |
| Working width |
(S) 220~3100mm, (O) 70mm~min.width |
| Working thickness |
6~65mm |
| Working-place protruding |
20~100mm |
| Feeding Speed |
(S) 5~25mm, (O) 8~40M/min |
| Cutter shaft dimension |
35mm, 40mm(S), 50mm |
| Dogs distance |
400mm |
| Dogs height |
0~15mm |
| Control voliage |
220V |
|
