HOME > Woodworking Machine > Tenoner: Woodworking Machine > Multiple Spindle Oscillation Mortiser TM-3

Multiple Spindle Oscillation Mortiser TM-3
Outstanding Features:
  • This highly productive mortiser is designed for producing various mortises simultaneously.
  • Flexible head combination to meet specific job requirements.
  • Double tables on front and back sides, permitting both sides operations for increased efficiency.
  • Cutter speeds are frwquency inverter controlled,providing variable speeds change.
  • The entire operation motions are conveniently controlled by simply pressing the foot switch.
  • Each carriage is adjusted independently.
  • Two speeds cutter oscillation permits high/low speed change.
  • Carriages slide on big steel rods. High speed cutter oscillation features maximum stability.
  • Mortise width and depth are adjustable.
  • The machine is designed for both mortising and drilling functions.
  • Carriages are well constructed for adjusting mortise width independently.

    Control Panel
    All of machine motions are grouped in one control panel for operation convenience, including cutter oscillation, motor ON/OFF control, and clamping cylinder control etc.    		 Variable Cutter Speed
    The cutter running is controlled by a high performance frequency inverter, permitting for variable speeds adjustment. Wide speed range is from 6,000 to 12,000 RPM.    		 TM-3 3~6 Head Configuration
    * 3 sets tilting carriages
    CARRIAGE
    * The machine is constructed of three tilting carriages and one horizontal carriage. Each carriage can be fitted with one or two mortising head as customer' s requirement.
    * Each carriage can be tilted independently. Maximum ti;ting angle is 20°.
    * Picture shown model TM-4 is equipped with three tilting carriages and one horizontal carriage.    		 MORTISING HEAD
    * Mortising head is directly driven by an independent 1.8 HP motor. Two cutters fitted on both ends of spindle perform both sides mortising simultaneously.
    * Mortising head position can be adjusted in right/left, up/down directions.
    * Collet chuck clamps/unclamps the cutter for quick tool change.    		 INDEPENDENT MORTISING HEAD CONTROL
    * Each mortising head is controlled by an independent swich. The operator may adjust mortise position as desired for maximum flexibility.

    Description :
    MODEL TM-3
    Numbers of carriage 3 set
    Numbers of spindle 3~6 pcs
    Maximum mortise width 100 mm
    Maximum mortise depth 50 mm
    Cutter diameter Ø6~Ø25 mm
    Cutter shank diameter Ø16 mm
    Min. distance between spindles 90~1000 mm
    Oscillation Speed(2 Speeds) 95~190
    Spindle speeds 6000~12000 R.P.M.
    Tilted mortise angle 20°
    Spindle motor 1.8HP
    Oscillation motor 1HP
    Working air pressure 5~6 kg/cm2
    Dust hood outlet diameter Ø4"
    Net weight 1350 kgs
    Gross weight 1650 kgs
    Machine size 2200 x 1420 x 1480 mm
    Packing size 2330 x 1600 x 1550 mm